Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
M4250 resetting management port config on power cycle
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2024-03-26
08:28 PM
2024-03-26
08:28 PM
M4250 resetting management port config on power cycle
Been attempting to setup and deploy two M4250-12M2XF switches to use in a front of house rack and stage rack. However it seems that whenever the switches lose power, IPV4 management configuration ends up resetting to DHCP. Have attached screenshots of settings before and after a simple power cycle. Is there something I'm missing elsewhere in my configuration?
Firmware Version 13.0.4.19
Message 1 of 1
Announcements