NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
ARP table changes - ORBI RBR40 and three sattelites
RBR40 and three sattelites Firmware V2.5.1.16 2-6 times per day I see the following change in the ARP table IP:192.168.1.250, Old MAC: ??-??-??-??-??-18, New MAC: ??-??-??-??-??-90 The ??-18 MAC ...
What is the distance between the router and satellite(s)? 30 feet is recommended in between RBR and RBS to begin with depending upon building materials when wirelessly connected. https://kb.netgear.com/000036466/How-far-should-I-place-my-Orbi-satellite-from-my-Orbi-router
Is Daisy Chain Enabled or disabled?
Has a factory reset and setup from scratch been performed since last FW update?
Set up IP address reservations for the RBS.
Daisy chain is enables
Try this, factory reset the RBR and RBS. I would disconnect all other devices from the RBR and RBS. Setup the RBR first using 1 wired PC. I would disable Daisy Chain first. Then sync the RBS to the RBR one at a time. Setup a IP address reservation ON the RBR for each of the RBS. Once they are connected and setup with the RBR. Turn them OFF and place back in there remote locations. I would connect the rest of your devices and network back to the RBR. Then turn on the RBS one at a time. Then let things settle in. Check the logs. Or turn on the RBS first, then connect the rest of your devices and networking to the RBR. Check logs.