NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
ATT BGW210-700 intermittently drops ethernet connection to Orbi RBR50v2 AP Mode
I have ATT Gigabit fiber that has worked well with Apple Extreme products that are long in the tooth. Orbi RBR50v2 firmware 2.5.1.8 is connected via ethernet to LAN #1 on ATT Router. I did not get ...
Has a factory reset and setup from scratch been performed since last update?
What mode is your using. I believe it's router mode and it can't be bridged.
This would be a double NAT condition which isn't recommended. https://kb.netgear.com/30186/What-is-Double-NAT
https://kb.netgear.com/30187/How-to-fix-issues-with-Double-NAT
Couple of options,
1. Configure the modem for transparent bridge or modem only mode. Then use the Orbi router in router mode. You'll need to contact the ISP for help and information in regards to the modem being bridged correctly.
2. If you can't bridge the modem, disable ALL wifi radios on the modem, configure the modems DMZ/ExposedHost or IP Pass-Through for the IP address the Orbi router gets from the modem. Then you can use the Orbi router in Router mode.
3. Or disable all wifi radios on the modem and connect the Orbi router to the modem, configure AP mode on the Orbi router. https://kb.netgear.com/31218/How-do-I-configure-my-Orbi-router-to-act-as-an-access-point and https://www.youtube.com/watch?v=H7LOcJ8GdDo&app=desktop
Please give option #2 a try first...
What is the distance between the router and satellite(s)? 30 feet is recommended in between RBR and RBS to begin with depending upon building materials when wirelessly connected. https://kb.netgear.com/000036466/How-far-should-I-place-my-Orbi-satellite-from-my-Orbi-router
What channels are you using? Auto? Try setting manual channel 1, 6 or 11 on 2.4Ghz and any unused channel on 5Ghz.
Any Wifi Neighbors near by? If so, how many?
Factory reset done. Appreciate your answer, but not my problem. Not sure you read my issue. I've read your answer before. I'm in AP Mode on the Orbi. Mine is not a WiFi but an ethernet issue between the AT&T modem and the Orbi. Timing, DHCP refresh, who knows? Thanks.
Well thats why we asked, we don't know what you have configured with the modem for sure, so we didn't want to assume. Some factory resets are needed after a FW update. Has been known to resolve some issues, Regardless of wifi or non wifi. Had to make sure what mode your modem was in since you didn't initially meantion it.
Do a seach here in the forums for your model modem. there have been others posting about it.
Good Luck.