Backhaul at 2.4 = low bandwidth

Has a factory reset and setup from scratch been performed since last FW update? 

---

Dooky wrote:

Hello,

 

I have an Orbi RBk50 and 1 satellite since beginning of december.

Everything was working flawless (300Mbps everywhere), but today, I had a huge bandwidth drop off.

 

Every devices connected to the satellite had 05-15 Mbps bandwith.

 

After some research, I did a Telnet on the router and here what I got :

 

Backhaul connectype : 2.4 Ghz

Bachaul RSSI : -62

Backhaul phytxrate : 96

Backhaul phytxrate : 86

 

The synced satellite connection shows as "Poor" in the web interface

 

I rebooted the satellite and then I got :

 

Backhaul connectype : 5 Ghz

Bachaul RSSI : -63

Backhaul phytxrate : 1300

Backhaul phytxrate : 1300

 

The synced satellite connection shows as "Good" in the web interface, and bandwith was like usual around 300 Mbps

 

Then half an hour later, again, the satellite switched to 2.4 Ghz with very poor bandwith. I couldn't work anymore.

 

My FW is v2.5.2.4

The satellite is 30 feet away from the router.

 

I changed the chanel to

Automatic  > 1 on 2.4Ghz

chanel 48 in 5Ghz

I acivated Beamforming

 

Since then I've been watching with some anxiety if the router won't switch to 2.4Ghz.

 

What can I do to avoid this ? I don't really care if it switch to 5Ghz to 2.4 Ghz as long as I don't have a huge bandwith loss...

 

Thank you very much for help.

 

 

 

 

---