NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Defect: OrbiOS 2.1.1.12 Attached Devices Widget & Page
In 2.1.12, the Attached Devices widget on the intitial page and the actual Attached Devices page do not populate even though devices and satellites are connected. Factory reset was performed mult...
OP here:
I purchased an Eero yesterday (3 unit 2nd gen and 1 beacon) and received it around 6 PM. It was set up and has now run 16 hours without a single disconnect among 62 continually connected devices, or disconnects from another 30 devices that connect periodically as measured by a Fingbox, not anecdotal observation.
Other than having to enter about 30 port forwarding rules via an app versus a web interface, the setup was brainless and provides great feedback on node placement signal strength!
My RBK50 system with a router and 2 sats is packed in its boxes and on Craigslist. So glad to finally have stable wifi thanks to Eero!!
I, too had tons of problems with this firmware. I dont understand why net gear can't make this hardware work after all of this time. I get the feeling they are relying on the chipset Manufacturers to make it right and all they do is build features around what they are given.
Anyway, I was only getting 40 mbps on my devices as well with this firmware. I have up and went back to the 2.0.76 firmware and it's been much more stable and getting full speed again.
Netgear, what is the problem?
Anyway, I was only getting 40 mbps on my devices as well with this firmware. I have up and went back to the 2.0.76 firmware and it's been much more stable and getting full speed again.
Netgear, what is the problem?
Has anyone tried a nvram clear? Does a factory reset clear nvram as well?