Message To avoid a conflict with your internet service provider, the IP address of your Orbi router

Question

Hello, hope someone can help me with this issue.

Since a couple of weeks our Wifi connection is lost almost daily. I reboot via de Orbi app the router, and than it works again for a day.

When I open the configuration of the orbi router on my laptop I get the message:

To avoid a conflict with your internet service provider, the IP address of your Orbi router has been updated to 10.0.0.1.

How can I solve this message?

I already updated the firmware to V2.6.1.40 and also I did a reset and a complete new installation, but this won't solve the message.

Kind regards,

Frans

CrimpOn · Answer

Fvd75&nbsp;wrote:Since a couple of weeks our Wifi connection is lost almost daily. I reboot via de Orbi app the router, and than it works again for a day.&nbsp;To avoid a conflict with your internet service provider, the IP address of your Orbi router has been updated to&nbsp;10.0.0.1.This message is a result of the Orbi being connected to a router that is using the private address space 192.168.1.x, which the Orbi typically expects to use on its LAN side. To avoid conflicts, Orbi changes the LAN side to 10.0.0.x.&nbsp;The most straight-forward way to stop this is to place the ISP device in "bridge" or "modem only" mode so that the Orbi will receive the public IIP address given out by the network provider.

Fvd75 · Answer

Thanks, our ISP already mentioned earlier the possibility of&nbsp;putting our modem in bridge mode.I'll call tomorrow to request this, hoping that will fix the problem.&nbsp;Kind regards,&nbsp;Frans

Forum Discussion

Message To avoid a conflict with your internet service provider, the IP address of your Orbi router

2 Replies