NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
madhatter
Mar 29, 2020Apprentice
Mixed satellite models RBR50 + RBS50 + RBS40 + RBS40 Networking issues and Firmware mess
This combination does work ... I have everything on f/w V2.3.5.30 -- so here are the issues: going into Attached devices, I see all 3 satellites going into (Online Update) Advanced | Administration...
FURRYe38
Mar 29, 2020Guru - Experienced User
Has a factory reset and setup from scratch been performed since last update t ov2.5.1.8? This version fixes device naming problems of prior versions of FW on the RBR50.
As long as the RBS are on the latest version of FW found on NGs web site, the RBS should all work for you.
What is the size of your home? Sq Ft?
What is the distance between the router and satellite(s)? 30 feet is recommended in between RBR and RBS to begin with depending upon building materials when wirelessly connected. https://kb.netgear.com/000036466/How-far-should-I-place-my-Orbi-satellite-from-my-Orbi-router
What channels are you using? Auto? Try setting manual channel 1, 6 or 11 on 2.4Ghz and any unused channel on 5Ghz.
Any Wifi Neighbors near by? If so, how many?
Try enabling Beamforming and MIMO(MIMO may or maynot be needed) and WMM. Under Advanced Tab/Advanced Settings/Wireless Settings
Try disabling the following and see:
Armor, Circle, Daisy Chain, Fast Roaming, IPv6 and Set 20/40Mhz Coexistence to 40Mhz only. Set Short preamble instead of Long preamble modes. Save settings and reboot the router and satellite(s).