New - Orbi RBR50 Router Firmware Version V2.7.2.104 Released

I upgraded from 2.5.1.16 to 2.7.2.104 yesterday. So far no issues.

In the past I tried several versions after 2.5.1.6 and had issues with all of them within a short time after upgrade.
So I went back to 2.5.1.16 all the time. I also had "minor" issues with 2.5.1.16, mainly after power outage with the satellites not getting stable connecction to the router. So I had always to power off the whole system (1xRBR50, 2xRBS50 via WiFi, 1xRBS50 over LAN, behind a switch) and power on first the router and then one satellite after the another.

This time, I just upgraded the satellites manually, one by one. And finally the router. No need to power cycle the satellites again. They all conneccted to the router and remain stable until now. Also the clients are connected without any intervention.

So it looks like we have finally a stable firmware.

Btw, I'm using the Orbi with these "features" enabled:

- Router mode (for me there is no option to use the Orbi only in AP mode)

- Enabled "Access Control"

- Defined some "Port Forwarding"

- using "Dynamic DNS"

- using "VPN Service"

- using "LAN Address reservation" (bind MAC to a fix IP address)