New - RBR50 / RBS50 Firmware Version v2.7.1.60 Officially Released

Try updating to v102. Should be seen in the RBRs web page after v60 is loaded. 

https://community.netgear.com/t5/Orbi/Orbi-RBR50-Router-Firmware-Version-V2-7-2-102/m-p/2027821/highlight/true#M109584

If you updated to v60, a factory reset and setup from scratch should be performed. Then test your configurations. 

v102 is working well for me and others though I can't confirm your portforward configuration. 

---

Endosmok wrote:

So I just took this update (V2.7.1.60) for my RBR50/RBS50 router and satellite.  This was a manual upload as neither unit would see any new firmware available (it's set to auto).

 

After the update, i noticed my port forwarding was no longer working.  I only had 3 services (Blueiris, Plex, and my Hopper).

They are still listed there but not longer accessible.  I've tried deleting and re-adding them but to no avail.

 

I also noticed that my UPnP is may be inoperable as well.  I cannot reach anything that is LISTED as ACTIVE in my UPNP status.  Nor can i access the UPNP to add BlueIris when I tried that method.  

 

Just checking to see what I can do prior to downgrading the firmware.  Maybe there's a setting I am missing?  but like I said... this occurred immediately after the FW update to 2.7.1.60.

 

Any assistance is appreciated.

 

Thanks

 

---