Orbi + OpenVPN = 1. Could not determine IPv4/IPv6 Protocol & 2. WARNING: No server certificate....

Question

&nbsp;I'm trying to setup the VPN via OpenVPN and the windows client.&nbsp; All is good on the router side, but within Windows, I'm getting two messages, while the VPN is constantly in "Reconnecting" state.&nbsp;1. Could not determine IPv4/IPv6 Protocol2. WARNING: No server certificate verification method has been enabled.&nbsp;Please advise how I correct these errors.&nbsp; Thank you.

PeteWalker74 · Answer

Can I get an answer on this please, Netgear support?

PeteWalker74 · Answer

Still no response.&nbsp; I get it's the holidays now, but his has been out there for weeks with no response.

DarrenM · Answer

You may want to check out this KB make sure you didnt miss anything.

&nbsp;

https://kb.netgear.com/23854/How-do-I-use-the-VPN-service-on-my-Nighthawk-router-with-my-Windows-client

&nbsp;

DarrenM

PeteWalker74 · Answer

Thanks, Darren.&nbsp; I followed those directions, which got me to where I'm at.&nbsp; Any other advice, that addresses the errors I'm receiving?

Forum Discussion

Orbi + OpenVPN = 1. Could not determine IPv4/IPv6 Protocol & 2. WARNING: No server certificate....

4 Replies