NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Orbi backhaul goes to wired when should be wifi
My setup is one router + 2 satellite. On one of the satellite I have connected via wire a SKY Q Extender. If I connect the SKY Q when all the WI FI is up, an IP is assigned to the extender by my main...
Is not the RBR that is read as wired but the RBS where the extender is connected to acquire the IP, like it would be any other IP device.
Thats because its connected wired so it would read as a wired connection...
Well is a wrong read. Is not wired to the RBR, just to another device that is the SKYQ Extender, no sense of reading the backhaul connection as wired. Just a bug.
Not a standard configuration if your using a extender with a RBS. Would not be a bug with Orbi. If an RBS is wired to an extender then it's communication is doing thru the wired, then to the extender. Orbi only reads status directly from the RBS or when the RBS is ethernet connected directly to the RBR or thru a switch. Even when the RBS is ehternet connecte, it will read as wired which is correct. Remove the extender between the RBR and RBS and you'll get correct status read from the RBS to the RBR.
However your configuration is working for you then don't worry about the status. Just it for what it does. Just know that Orbi doesn't fully support your configuration.
Good Luck.- Maybe I'm not clear. Gain the extended is a SkyQ extender. It just extend the SkyQ 5G (different than my WiFi) and not my WiFi managed with the Orbi. I need to connect the Sky Q to the Orbi to be able to get an io address from my lan to reach the other Multivision via IP. Again if I attach the SkyQ AFTER the RBS is booted The backhoul remain on wifi and my other RBS will daisy chain and all works but if the RBS for any reason restart the backhaul is marked as wired and the other RBS do not daisy chain.