NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
ORBI CBR40 slow device speeds when not shown as connected device
Orbi CBR40, v2.3.5.12__1.0.8 Hello! When a particular computer connects to the Orbi, it shows up as a connected device with proper speeds (320mbps). But soon after, the computer is lost as a...
What is the size of your home? Sq Ft?
Do you have a RBS connected as well?
Is the PC wired or wireless connected to the CBR?
What is the mfr and model# of the wired and wireless adapters in this PC?
What channels are you using? Auto? Try setting manual channel 1, 6 or 11 on 2.4Ghz and any unused channel on 5Ghz.
Any Wifi Neighbors near by? If so, how many?
https://kb.netgear.com/19668/Link-Rate-and-Transfer-Speed
Try enabling Beamforming and MIMO(MIMO may or maynot be needed) and WMM. Under Advanced Tab/Advanced Settings/Wireless Settings
Try disabling the following and see:
Armor, Circle, Daisy Chain, Fast Roaming, IPv6 and Set 20/40Mhz Coexistence to 40Mhz only. Set Short preamble instead of Long preamble modes. Save settings and reboot the router and satellite(s).
Has a factory reset and setup from scratch been performed since last FW update?