Hi, community,

I could do with your help again.

Since my last post I did the following:

- Boot ReadyNAS w/o factory reset with my old disk in bay #2, bay #1 empty. (The only variation that worked without error messages.)

- Restore my data from external backup

- Insert the "corrupt boot" disk #1 in bay #1. ReadyNAS accepted the disk and sychronized disk #1 successfully.

Everything was okay and I started the backup jobs again.

Then after some hours, the same error happend again:

ReadyNAS stopped, system hangs. No access. RAIDar could not find the NAS. Cannot switch off the NAS.

(One backup job was running when the error occured. Squeezebox radio was also connected to the NAS but in standby mode, i.e. no streaming in progress.)

Restart the NAS after power off/on results in (RAIDar status messages):

- "Power up the system..."

- "Checking file system" (up to 100%)

The system is now up again and started synchronizing (still in progress for the next 3-4 hours). Status of both disks is ok.

The protocol contains the following messages (during/after reboot):

- Volume scan found and corrected errors.
- RAID sync started on volume C.
- Reallocated sector count has increased in the last day. Disk 2: … (This is the old disk that I exchanged last year because of this warnings. In my opinion not the cause of the error, bacause it happend before with 2 disks inserted without such sector faults.)
- A previous run of backup job is still running. … (The job is actually not running any more)
- System is up.

I'm afraid that it will happen again.

Any suggestions?

Thanks,

Peter

Forum Discussion

Orbi Guest Wifi Settings