NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Orbi port forwarding problem
Hi, I'm having problems with port forwarding. I did this before so simply with an Asus router but I'm getting frustrated here!
I have a public static IP with my ISP provider, I have checked that t...
What FW is currently loaded?
What is the Mfr and model# of the ISP modem the NG router is connected too?
When uPnP is enabled, be sure to disable any Port Fowarding configurations. You may also try to set NAT Filter to Open and test as well.
Besure to set up an IP address reservation ON the router for the NAS.
FW is 2.1.4.16
Modem mfr Technicolor (I don't see how this could be an issue since I had it connected to the Asus and working perfectly)
When I had upnp enabled I disabled the port forwarding. The NAT Filter is disabled on the modem from my ISP since it is linked to a static public IP, so they let it open. So I have NAT enabled on my Orbi, otherwise I would be out in the open right? I have all my devices with reserved DHCP including the NAS.
There a model # of the modem? Just checking for router here is all.
TC 7300
I believe your modem is a modem/router combo:
https://fccid.io/H8N-TC7300/User-Manual/User-Manual-TC7300-d1TI-rev-pdf-2662571.pdf
This can effect Port usage and NAT on the Orbi.
I would try 1 of the following:
1. Configure the modem for transparent bridge mode. Then use the Orbi router in router mode. You'll need to contact the ISP for help and information in regards to the modem being bridged correctly.
2. If you can't bridge the modem, disable ALL wifi radios on the modem, configure the modems DMZ for the IP address the Orbi router gets from the modem. Then you can use the Orbi router in Router mode.
3. Or disable all wifi radios on the modem and connect the Orbi router to the modem, configure AP mode on the Orbi router.