NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Orbi (RBK50) with a replaced xfinity gateway
i have an Orbi that is up and running in AP mode with an Xfinity gateway. I want to now change the set up and put the gateway in bridge mode and then use my Orbi in Router mode. -Should I make the cha...
Thanks for confirming. i assume leave all connections as is, or should is disconnect the Orbi from the gateway when performing the change to bridge mode?
You can leave them all connected. Be sure you are using the WAN port on the RBR to connect to the ISP modem.
- My ISP gateway is in bridge mode, if I hard wire into the orbi it does pass a connection to the internet but I can not log into the Orbi to change it from Access point to Router mode. Any suggestions? Orbilogin .com and .net don’t connect.
Factory reset the RBR with a wired PC connected to the RBR. Use a web browser and walk thru the RBR setup wizard at 192.168.1.1.
Zip90 wrote:
My ISP gateway is in bridge mode, if I hard wire into the orbi it does pass a connection to the internet but I can not log into the Orbi to change it from Access point to Router mode. Any suggestions? Orbilogin .com and .net don’t connect.