Orbi RBR50 on V2.5.0.38 no longer shows attached devices after changing IP range

Question

So I'm trying to assign a static IP for a raspberry pi. I originally assigned it using the IP Reservation panel and assigned, 192.168.1.97, rebooted, and then when I would connect the pi to the network, the network went down. I then read another thread where someone recommended changing the range to 192.168.1.100 - 192.168.1.200 so I changed the IP range to that.

Now the network comes up, but every time I try to load the Attached Device page it hangs, and if I try to change the IP range back to the original range, I get a:

"400 Bad Request

This server does not support the operation requested by your client."

Displayed. Any help would be appreciated!

SW_ · Answer

v2.5.0.38 was bad/pulled from NG support website.&nbsp; The new attached device regconition feature has since been fixed in the latest firmware version 2.5.1.8.

MCO79 · Answer

Im on 2.5.1.8, doesn't work for me. I have a new thread going

FURRYe38 · Answer

https://community.netgear.com/t5/Orbi/RBR50-no-longer-showing-Detected-Devices/m-p/1868799/highlight/true#M83559MCO79&nbsp;wrote:Im on 2.5.1.8, doesn't work for me. I have a new thread going&nbsp;

Forum Discussion

Orbi RBR50 on V2.5.0.38 no longer shows attached devices after changing IP range

3 Replies