NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Orbi RBR50 Working Strange?
So I have an Orbi setup with 2 satellites. My "office" location satellite seems to act "off." Despite showing under Attached Devices fine (Backhaul Status GOOD) Browsing attached devices however ...
Can you access the RBS web page to see what FW version is loaded on it? It should be same version as whats loaded on the RBR?
What is the size of your home? Sq Ft?
What is the distance between the router and 📡 satellite(s)? 30 feet or more is recommended in between RBR and RBS📡 to begin with depending upon building materials when wirelessly connected.
FURRYe38 , all sats and router are on V2.7.3.22.
Home is roughly 2900sq feet. Sat 1 is about 45' away in the garage. Router is in center of home and sat 2 is roughly 20' away. Both sats are hardwired though, so not sure that matters right? All are on the same level of the house (ground floor).
20 feet is too close, wired or wireless.
Are the RBS directly connected to the back of the RBR or is there a LAN switch in between?
- So having the satellite less than 30’ would cause those issues? That doesn’t seem to make much sense. It also worked seemingly fine for 4 months until recently.
I have a switch between the router and sats, the same switch for both.
If I factory reset my full set (router + sats) is it not advisable to import saved settings (I have a lot of tweaks i am sure)? I took the one "bad" Orbi out of the equation and it wont even remove anymore. I have had it powered off for a day, i disconnected in from settings 5 times and it keeps showing up.
Need to factory reset and setup from scratch. Seems like something is in a bad state on the RBR and RBS and they need to be reset.