NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.

Forum Discussion

pcolsen's avatar
pcolsen
Aspirant
Jan 16, 2021

Orbi router has 700Mbs from Modem, gives 2.0Mbs over WIFI

I have an RB50 router with firmware V2.5.2.4 connected to two satellites.   My Orbi base station reports that it's getting 700Mbps download.  My laptop is getting 2.1Mbs, and this has gone as low a...
FURRYe38's avatar
FURRYe38
Guru - Experienced User
Jan 16, 2021

What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?
What speed do you get with connecting the laptops ethernet connection to the back of the RBR? 

 

What is the size of your home? Sq Ft?
What is the distance between the router and satellite(s)? 30 feet or more is recommended in between RBR and RBS to begin with depending upon building materials when wirelessly connected.

What channels are you using? Auto? Try setting manual channel 1, 6 or 11 on 2.4Ghz and any unused channel on 5Ghz.
Any Wifi Neighbors near by? If so, how many?
https://kb.netgear.com/19668/Link-Rate-and-Transfer-Speed

 

Try enabling Beamforming and MIMO(MIMO may or may not be needed) and WMM. Under Advanced Tab/Advanced Settings/Wireless Settings

Try disabling the following and see:
Armor, Circle, Daisy Chain, Fast Roaming, IPv6 and Set 20/40Mhz Coexistence to 40Mhz only. Set Short preamble instead of Long preamble modes. Save settings and reboot the router and satellite(s).

 

One User Experience/Configuration:
https://community.netgear.com/t5/Orbi/Most-Stable-Orbi-Configuration/m-p/1941087/highlight/true#M97026

pcolsen wrote:

I have an RB50 router with firmware V2.5.2.4 connected to two satellites.

 

My Orbi base station reports that it's getting 700Mbps download.  My laptop is getting 2.1Mbs, and this has gone as low as 1.0Mbs on WIFI.  I have a physical connection through a pair of TP-Link Gigabit Powerline modems that provides about 7 Mbps.

 

I had this performace earlier.  Since then I have rebooted the router several times and done one factory reset.  The modem did increase speed immediately after the factory reset, but both WIFI and ethernet performacne had returned to the low speeds above.

 

I am serving two laptops, three printers, and some Amazon Echo devices.  I have attached an older Netgear router to support 2.4Ghz smart devices such as bulbs.  I have disconnected the attached modem and noticed no significant increase.