NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
Orbi: Why do I have to factory reset to get Attached Devices to show?
Firmeware version: V2.5.1.8 For some reason, every month or so, my Orbi loses the ability to show attached devices. And then it is factory reset time. Why? What's going on? This supe...
So I didn't end up factory resetting the router. It just seemed like such a drag to figure out which device was which and reenter names for them.
Saturday and Sunday the attached devices list still said 0 satellites, 0 attached devices.
This morning I was about to bite the bullet and factory reset, but got distracted with something else.
This after I was going back to it, when lo and behold, the attached devices list started working again.
Still on V2.5.1.8
What is good?
And is downgrading possible?
lokimon wrote:
What is good?
And is downgrading possible?
go to the dowload area and enter your model number
I'm running RBR50 (Orbi Router) Firmware Version 2.3.5.30 since Oct 2019
lokimon
So I didn't end up factory resetting the router. It just seemed like such a drag to figure out which device was which and reenter names for them.
Saturday and Sunday the attached devices list still said 0 satellites, 0 attached devices.
This morning I was about to bite the bullet and factory reset, but got distracted with something else.
This after I was going back to it, when lo and behold, the attached devices list started working again.
Still on V2.5.1.8
Glad it's working. Please mark your thread as solved so others will know.
Please do a backup configuration to file for safe keeping. Helps save time if a reset is needed in the future.
Enjoy. :smileywink:
lokimon wrote:So I didn't end up factory resetting the router. It just seemed like such a drag to figure out which device was which and reenter names for them.
Saturday and Sunday the attached devices list still said 0 satellites, 0 attached devices.
This morning I was about to bite the bullet and factory reset, but got distracted with something else.
This after I was going back to it, when lo and behold, the attached devices list started working again.
Still on V2.5.1.8
But how would I know if the settings were or were not causing the issues. :)
