AH ok, I forgot that you had a 40 series. Sometimes they have 40 series betas. 

They do have new code for the 40 series sysetms:

https://community.netgear.com/t5/Orbi/New-NetGear-Orbi-20-40-Series-Firmware-Version-2-3-0-28/td-p/1714639/jump-to/first-unread-message

Load the satellites first directly to v28. You do need to apply v212 first on the RBR, THEN apply v28 lastly. I would do a full factory reset and setup from scratch. Save off a configuration to file for safe keeping after the system is set up. 

---

bb9394 wrote:

Thanks

 

I am running an RBR40 with one RBS40, which are connected via RJ45 cables (as there are just too much walls in the house blocking the signals). The RBR40 is link to a router provided by ISP which does not require log in.

 

I have now turned off Access Control, and it seem to work fine.

 

I have read your recommendation on the BETA, but it said it is for the RBR50 only, so I am not sure if it would work on my system.

 

Furthermore, my RBS40 satellite is now playing weird, with authentication error for both my phone and my tablet (LG G5 and Samsung 7.1 Tablet). My firmware is running on 2.2.1.210, and I read that there is a v2.3.0.32 but again it marked as item for the RBR50 only. 

---