NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.

Forum Discussion

anitachan99's avatar
anitachan99
Initiate
Apr 26, 2020
Solved

RBK50 satellite not stable

I placed and setup my satellite with LED Blue light on, after several hours of usage, my mobile device disconnected with wifi with message "cannot get IP address".  Same thing happened after I reboot...
  • FURRYe38's avatar
    FURRYe38
    Apr 29, 2020

    Sounds good. 

     

    AT some point you can enable Armor and Circle. There have been some resports that Circle has been causing problems. NG seems to be aware of this issue and is working on it. 

     

    I would make a backup configuration to file for safe keeping. Saves time if a reset is needed. Then at some point, try enabling Armor or Circle and see how it goes. If you run into something after enabling those apps, You can factory reset and apply the backup confuration from file. 

    anitachan99 wrote:

    Thanks for your advice!

     

    I applied your advice and it seems ok.  Let's monitor the performance for a longer period.

     

    BTW, by applying this solution, does it mean that I cannot enable the Circle/Armor as you advised disable Circle/Armor?

     

    Thanks .... Anita

     

FURRYe38's avatar
FURRYe38
Guru - Experienced User
Apr 27, 2020

 

What is the distance between the router and satellite(s)? 30 feet is recommended in between RBR and RBS to begin with depending upon building materials when wirelessly connected. https://kb.netgear.com/000036466/How-far-should-I-place-my-Orbi-satellite-from-my-Orbi-router


Any Wifi Neighbors near by? If so, how many?

 

Try enabling Beamforming and MIMO(MIMO may or maynot be needed) and WMM. Under Advanced Tab/Advanced Settings/Wireless Settings

Try disabling the following and see:
Armor, Circle, Daisy Chain, Fast Roaming, IPv6 and Set 20/40Mhz Coexistence to 40Mhz only. Set Short preamble instead of Long preamble modes. Save settings and reboot the router and satellite(s).

 

Please try a factory reset and setup from scratch with the RBR and RBS.

  • anitachan99's avatar
    anitachan99
    Initiate
    Apr 28, 2020

    Thanks for your advice!

     

    I applied your advice and it seems ok.  Let's monitor the performance for a longer period.

     

    BTW, by applying this solution, does it mean that I cannot enable the Circle/Armor as you advised disable Circle/Armor?

     

    Thanks .... Anita

    • FURRYe38's avatar
      FURRYe38
      Guru - Experienced User
      Apr 29, 2020

      Sounds good. 

       

      AT some point you can enable Armor and Circle. There have been some resports that Circle has been causing problems. NG seems to be aware of this issue and is working on it. 

       

      I would make a backup configuration to file for safe keeping. Saves time if a reset is needed. Then at some point, try enabling Armor or Circle and see how it goes. If you run into something after enabling those apps, You can factory reset and apply the backup confuration from file. 

      anitachan99 wrote:

      Thanks for your advice!

       

      I applied your advice and it seems ok.  Let's monitor the performance for a longer period.

       

      BTW, by applying this solution, does it mean that I cannot enable the Circle/Armor as you advised disable Circle/Armor?

       

      Thanks .... Anita