NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
RBK50 will not save second ssid
I bought a refurbished RBK50 kit from Microcenter. It seems to work okay except for one thing. It won't allow me to save the second ssid. I go to the debug page, turn telnet on, telnet to the rout...
Thanks for responding. I did all the things that the document you linked to said that I should. And for a few minutes, it does work. Unfortunately, in my case, the router reverts to the single ssid after a short amount of time. I tried this several times. I even check the satellite to make sure that the ssids were propagated after the change and they are. Unfortunately, the system resets after a few minutes and reverts to a single ssid configuration. The other changes I put in place (new router address, DHCP configuration, DMZ setup etc.) are retained. Only the second ssid setup is reverting to the previous configuration.
One thing I haven't tried is to change the ssid after doing a reset. I'll save the configuration, reset the router, and see what happens. It should not make a difference, but perhaps the second ssid can only be set when the router is at the default 192.168.1.1 address.
If it's not too personal, would you be willing to share the reason for devoting this much effort to creating a second SSID on the Orbi that was clearly designed to host one SSID?
I am 99.9% certain that the IP address of the Orbi router has no bearing on this issue.
I don't have to have two ssids. I can do with one, and in my use case, it works well enough. Though I always like having finer control of which devices use which band, etc. And since one can supposedly do it, I tried to do it and followed the procedures outlined but found a problem. I guess curiosity why something failed is the paramount reason for this query. I want to try to understand what's happening and why.
I don't think it's the router IP address that's causing the problem either, but I'll reset the router and see what happens. I am using the latest firmware.
