Forum Discussion

Luminary

Mar 16, 2021

Solved

RBR50 - 2.7.2.104 firmware - Issues?

To whom it may concern, FURRYe38: After upgrading my firmware to 2.7.2.104, I have been having issues. Devices successfully connect to the Orbi, but have no internet. If I reboot the Orbi and ...

BillYoung
Mar 16, 2021
Hi FURRYe38:

So far so good (very short timeframe). Also, changed the NTP server from Netgear's to time.nist.gov. If I continue to have connectivity issues, I'll do the factory reset and re-setup from scratch. Thanks for your help.

FURRYe38

Guru

Mar 20, 2021

Are you using DST and or Traffic Meter currently?

BAM2019 wrote:
Updated to ORBI firmware 2.7.2.104 and internet dropped several times daily. Before firmware update no problems. Using Spectrum Business 1Gig internet. I rolled back to ORBI firmware V2.6.1.40 and so far no issues.

BAM2019

Star

Mar 20, 2021

DST I just unchecked but the Meter is set to Auto. Should I turn off the meter? Thanks :)

FURRYe38
Guru
Mar 20, 2021
Yesm Disable TM. Re-enable DST.
- BAM2019
  Star
  Mar 20, 2021
  Ok, so ORBI firmware "V2.7.2.104" is ok as long as the Traffic Meter is unchecked (off). And just to be sure you say it is ok to check the box next to Daylight Savings Time to "Automatically adjust for daylight savings time" and this should be turned on? And I have a check next to "Use default NETGEAR NTP server" is ok too?
  
  Again, thank you for your help :)
  - FURRYe38
    Guru
    Mar 20, 2021
    Yes and Yes.
    BAM2019 wrote:
    Ok, so ORBI firmware "V2.7.2.104" is ok as long as the Traffic Meter is unchecked (off). And just to be sure you say it is ok to check the box next to Daylight Savings Time to "Automatically adjust for daylight savings time" and this should be turned on? And I have a check next to "Use default NETGEAR NTP server" is ok too?
    
    Again, thank you for your help :)