Forum Discussion

Luminary

Mar 16, 2021

Solved

RBR50 - 2.7.2.104 firmware - Issues?

To whom it may concern, FURRYe38: After upgrading my firmware to 2.7.2.104, I have been having issues. Devices successfully connect to the Orbi, but have no internet. If I reboot the Orbi and ...

BillYoung
Mar 16, 2021
Hi FURRYe38:

So far so good (very short timeframe). Also, changed the NTP server from Netgear's to time.nist.gov. If I continue to have connectivity issues, I'll do the factory reset and re-setup from scratch. Thanks for your help.

Ursa99

Star

Mar 28, 2021

I upgraded from V2.5.2.4 directly to V2.7.2.104 and had no issues after the update. I did not touch the timeserver or the traffic meter settings (which I've never changed) and did not power off the router. The update was uneventful, the two satellites connected and all 25 devices have connected properly. I am using the Orbi in AP mode with no inputs on it used except the Etherent into it from my router. I don't know if the FW is bad or not but this is my experience.

vajim

Master

Mar 28, 2021

Ursa99 wrote:
I upgraded from V2.5.2.4 directly to V2.7.2.104 and had no issues after the update. I did not touch the timeserver or the traffic meter settings (which I've never changed) and did not power off the router. The update was uneventful, the two satellites connected and all 25 devices have connected properly. I am using the Orbi in AP mode with no inputs on it used except the Etherent into it from my router. I don't know if the FW is bad or not but this is my experience.

How long has it been?