RBR50 connection issues.

What Firmware version is currently loaded?
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?

What is the size of your home? Sq Ft?
What is the distance between the router and satellite(s)? 30 feet is recommended in between RBR and RBS to begin with depending upon building materials when wirelessly connected. https://kb.netgear.com/000036466/How-far-should-I-place-my-Orbi-satellite-from-my-Orbi-router

What channels are you using? Auto? Try setting manual channel 1, 6 or 11 on 2.4Ghz and any unused channel on 5Ghz.
Any Wifi Neighbors near by? If so, how many?

Try enabling Beamforming and MIMO(MIMO may or maynot be needed) and WMM. Under Advanced Tab/Advanced Settings/Wireless Settings

Try disabling the following and see:
Armor, Circle, Daisy Chain, Fast Roaming, IPv6 and Set 20/40Mhz Coexistence to 40Mhz only. Set Short preamble instead of Long preamble modes. Save settings and reboot the router and satellite(s).

Has a factory reset and setup from scratch been performed since last FW update? 
Press the back reset button for 15 seconds then release. 

---

gpeck54 wrote:

Orbi needs to be reset 1 to 4 times a day. It seems to start this after a small power outage or I have turned it off for some reason.

After a couple of weeks it seems to get better until the next episode.

 

I have done firmware updates and did a factory reset without any results. Also done numerous power recycles with modem.

 

It may be a coincidence, but these problems seem to have started when i tried the trial version of Armor Security. The month I trialed that it started to be reset everyday. It has continued after the trial and is no longer being used.

---