NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
RBR50 firmware update-this firmware file is incorrect
I have an Orbi RBR50 and am unable to update the firmware. The message in the autoupdate section of the router management is that the "update has failed". I have tried repeatedly to manually update a...
What Firmware version is currently loaded?
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?
Thanks for the quick reply.
Firmware: V2.1.4.16_1.0.0.1
Modem: Fios G1100
ONT: Verizon 1-211M-L
I should add that the Orbi is not functioning as the router but is in AP mode.
Ok on AP mode. Your good then.
helpme1234 wrote:I should add that the Orbi is not functioning as the router but is in AP mode.
Ah ok, so your on a old version which you need to update to v212 I believe on the RBS first, then RBR lastly. Once these are at v212, you can Go directly to 40 on the RBS, I believe then try on the RBR lastly.
If you can get access to the RBS web page, send the FW file to the RBS web page first. Then update the RBR.
Your ISP mode has a built in router just FYI. This would be a double NAT (two router) condition which isn't recommended. https://kb.netgear.com/30186/What-is-Double-NAT
https://kb.netgear.com/30187/How-to-fix-issues-with-Double-NAT
Couple of options,
1. Configure the modem for transparent bridge or modem only mode. Then use the Orbi router in router mode. You'll need to contact the ISP for help and information in regards to the modem being bridged correctly.
2. If you can't bridge the modem, disable ALL wifi radios on the modem, configure the modems DMZ/ExposedHost or IP Pass-Through for the IP address the Orbi router gets from the modem. Then you can use the Orbi router in Router mode.
3. Or disable all wifi radios on the modem and connect the Orbi router to the modem, configure AP mode on the Orbi router. https://kb.netgear.com/31218/How-do-I-configure-my-Orbi-router-to-act-as-an-access-point and https://www.youtube.com/watch?v=H7LOcJ8GdDo&app=desktopThe RBS's are already at version V2.5.1.16
I had tried to run the modem in bridge mode, but the connection was unstable, in part due to the Verizon periodic change in IP addresses. I spent hours on this. I have the verizon radios off and am running in AP mode. I'll try your middle suggestion, but everything I've found so far suggests that AP mode is the only way to get this to work. Thanks again.