NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
RBR50 heavy battery drain on iPhone SE
Purchased RBR50 on 08 October 2018. Firmware V2.2.1.210
One Orbi Satellite-1
Six connected devices: Two iPhones running OS/12, a Windows 10 Desktop, a printer, a Roku, a sterio receiver TX-8170
...
Good to hear. Mark this thread as solved so others will know when needed.
Enjoy. :smileywink:
JTrtt wrote:
I promised to update after a few days of testing. After doing the following, the battery drain on my iPhone SE has improved so that it is only consuming 10%-20% per day which is very much better than I had before. I am encouraged. Thank you FURRYe38 and pdang for the help!
Here is what I did:
On the Orbi RBR50
- Enabled MU-MIMO
- Enabled Beamforming
- Enabled Fast Roaming
- Enabled Daisy Chain
On the iPhone SE
- Disabled Screen Time (a huge improvement; see https://www.idownloadblog.com/2018/10/08/ios-12-screen-time-iphone-battery-drain/)
- Turned off Background refresh on apps I don't need
- Started using Airplane Mode + WiFi while at home. An article suggested this would save both because both radios are not on and it is not constantly checking for cell coverage. I don't know if that is true but it seems to have helped.
Any status on this?
JTrtt wrote:
Purchased RBR50 on 08 October 2018. Firmware V2.2.1.210
One Orbi Satellite-1
Six connected devices: Two iPhones running OS/12, a Windows 10 Desktop, a printer, a Roku, a sterio receiver TX-8170
MU-MIMO is disabled
Beamforming is disabled
Fast Roaming is disabled
Daisy Chain is enabled
The battery on my iPhones (an SE and a 7) drain visibly while I watch. In a matter of hours, it went from 60% to 10% battery.
Did not have this problem with the older wireless router.
I have two weeks to solve this before returning the device to BestBuy to get a competitor product.
I would appreciate any help.
Thank you for the advice so far. I have done the following:
- Enabled Beamforming and MIMO
- Disabled Screentime on my iPhones (by default, it was enabled on my phone and disabled on my wife's)
- Reduced power on the 2.4 GHz channel to 25% (only used by my printer)
I am also looking at using Airplane Mode (with wireless on).
I reckon I need to test this for a day or two to see if this resolved the issue.
I will update this note by end of the week.
Sounds good.