NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
RBR50 Router Firmware corrupt - not able to flash - cannot connect - no IP visibility
Kevin & ..
Thank you both for your feedback and community support - stubborn is one word I must have tried this 20 times
I followed to the letter (same as prior) but I now see that on step 10 - turning the router back on I do not get a flashing orange light - it stays a constant green with the LED ring still flashing white?
Turn your router off for 10 seconds.
Turn your router back on.
Wait for the Power LED to light orange and start flashing.
When the Power LED is flashing, click Put in Tftpd64 to initiate the firmware upload. The upload might take a few minutes.
Thank you both for your feedback and community support - stubborn is one word I must have tried this 20 times
I followed to the letter (same as prior) but I now see that on step 10 - turning the router back on I do not get a flashing orange light - it stays a constant green with the LED ring still flashing white?
Turn your router off for 10 seconds.
Turn your router back on.
Wait for the Power LED to light orange and start flashing.
When the Power LED is flashing, click Put in Tftpd64 to initiate the firmware upload. The upload might take a few minutes.
I assume the router is not connecting to the PC so will not allow the flash - also tried swapping the TCP/IPv4 from 0 to 1 as per video no joy - it pains me to say it but I am clearly not techy to sort this out - painfully expensive but have ordered a new system -