NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
RBR50: Satellite not connecting - I can see the Satellite listed, but ...
The RBR50 router seems to running perfectly. The latest firmware has been installed ( V2.5.1.8). The Attached Devices screen shows the satellite (RBS50), but IP Address, Connection Type, and Backha...
And you updated both RBR and RBS FW versions?
Has a factory reset and setup from scratch been performed since last FW update?
Are you getting any top ring LED indication on the RBS during it's sync process?
https://kb.netgear.com/31030/What-do-the-LEDs-on-my-Orbi-mean
What is the distance between the router and satellite(s)? 30 feet is recommended in between RBR and RBS to begin with depending upon building materials when wirelessly connected. https://kb.netgear.com/000036466/How-far-should-I-place-my-Orbi-satellite-from-my-Orbi-router
What channels are you using? Auto? Try setting manual channel 1, 6 or 11 on 2.4Ghz and any unused channel on 5Ghz.
Any Wifi Neighbors near by? If so, how many?
Try enabling Beamforming and MIMO(MIMO may or maynot be needed) and WMM. Under Advanced Tab/Advanced Settings/Wireless Settings
Try disabling the following and see:
Armor, Circle, Daisy Chain (Needs to be disabled for wire connected RBS), Fast Roaming, IPv6 and Set 20/40Mhz Coexistence to 40Mhz only. Save settings and reboot the router and satellite(s).