NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
aidenmcdaniel
Nov 25, 2020Aspirant
RBR50 setup with network switch
I am going to be setting up my RBR50 with a network switch. The reason for this is because I'm on a community network with no access to the main network modem. Currently I'm setup using a linksys wifi...
- Nov 26, 2020
Yes, like I said, if you need a switch then install one at the walll out let then connect the RBR to the switch. But nothing else can connect to the switch. If you need more ports in back of the RBR, then you can add a switch here as well.
Good Luck.
FURRYe38
Nov 25, 2020Guru - Experienced User
Something to ask the Mfr of this switch or your network administrator/ISP if your network. IF there already is a private network, you could configure the Orbi system for AP mode.
Good Luck.
- aidenmcdanielNov 25, 2020AspirantI dont quite understand? The main community comcast modem sits in a basement electrical closet in the main common house. According to the orbi setup instructions, I would plug the orbi into the modem and reboot the modem. Not possible for me to do this. Instead that modem is constantly on and running the network for the whole community. I'm simply plugged into a network jack in my house - which is on a patch panel. Because there is only one main line, I can't patch my office network jack into the main line, and the orbi. Instead, I will be plugging the switch into the main port, and running a patch from the switch to the network jack in the office, and then from the switch to the orbi. I'm just wondering if this setup will be similar to what I had with the linksys wifi router?
- FURRYe38Nov 25, 2020Guru - Experienced User
I would first try connecting the RBR to the wall jack and see if it gets the signal.
Have a wired PC or laptop connected to the back of the RBR and use a web browser at 192.168.1.1 and look at the Basic tab or Advanced Tab pages to see if the RBR reports the Internet connection after you connect the RBR to the wall jack to the Yellow port on the back of the RBR.
- aidenmcdanielNov 25, 2020AspirantI appreciate all the help you are trying to give friend - but I need to install a switcher. The orbi would then plug into that switcher. I'll just give it a go and see if I'm successful. Thanks for trying though.
- CrimpOnNov 25, 2020Guru - Experienced User
It would help to see a rough diagram of these parts. Nothing fancy, just sketch it out in pencil, scan or take a photo of it, and attach it using the "Browse" button in the lower left.
Just off the top of my head, the Orbi router should simply "drop in" where the Linksys is. They are essentially the same thing (WiFi router), except that the Orbi does not have antennas sticking up.
- aidenmcdanielNov 25, 2020AspirantYes - I know that the Linksys and Orbi are the same thing essentially. What I'm asking is how to replace the linksys with a switch. Attached is the photo