NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
RBR50 started assigning 192.168.10.x instead of 192.168.0.x to Apple devices
I have been using a Netgear Orbi RBR50 for many years, and it's worked well. I've configured my internal network (wired and wifi) to assign addresses of 192.168.0.x (third digit zero), with many add...
What Firmware version is currently loaded?
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?
Has a power off for 1 minute then back ON with the ISP modem and router been performed since last update?
Be sure to restart your network in this sequence:
Turn off and unplug modem.
Turn off router and computers.
Plug in and turn on modem. Wait 2 minutes for it to connect.
Turn on the router and wait 2 minutes for it to connect.
Turn on computers and rest of network.
I forgot to post the firmware version! It is V2.7.4.24, same for the RBR50 and the two RBS50 satellites. It's connected directly to a Verizon FIOS Alcatel ONT I-211M-L. The NetGear Orbi handles DHCP assignments - it plugs directly into the ONT. I.e. I'm not using any Verizon routers, only the ONT.
I can try your reset sequence later tonight. I'll get in a lot of trouble if I take the network down during the day! 🙂
John
Might update FW as well when you get time:
I had gone to the Advanced -> Administration -> Firmware Update section of the admin module. It says that there is no new firmware version available. I didn't realize there was a newer firmware version available for manual installation! I'll definitely consider giving it a try.
Sometimes new FW doesn't get put up on the AU servers. Minor updates mostly. Major ones seem to get put up when those happen.