NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.

Forum Discussion

danfCO's avatar
danfCO
Follower
Mar 16, 2020

RBR50 w2 satellites dropping wifi every night

I have one RBR50 and two RBS50 satellites all running V2.5.1.8. Internet has been very stable. Each night over the last 5 nights, My devices are not able to reach the internet. When I log into my orbi system, it says the internet connection is good. I can't seem it isolate the issue. I reboot the system in the morning and it then works fine for the day unitl I wake up and find the same issue. 

3 Replies

  • Retired_Member's avatar
    Retired_Member

    danfCO wrote:

    I have one RBR50 and two RBS50 satellites all running V2.5.1.8. Internet has been very stable. Each night over the last 5 nights, My devices are not able to reach the internet. When I log into my orbi system, it says the internet connection is good. I can't seem it isolate the issue. I reboot the system in the morning and it then works fine for the day unitl I wake up and find the same issue. 


    Get rid of V2.5.1.8.

  • What is the Mfr and model# of the ISP modem the NG router is connected too?

    What is the size of your home? Sq Ft?
    What is the distance between the router and satellite(s)? 30 feet is recommended in between RBR and RBS to begin with depending upon building materials when wirelessly connected. https://kb.netgear.com/000036466/How-far-should-I-place-my-Orbi-satellite-from-my-Orbi-router

     

    What channels are you using? Auto? Try setting manual channel 1, 6 or 11 on 2.4Ghz and any unused channel on 5Ghz.
    Any Wifi Neighbors near by? If so, how many?

     

    Try enabling Beamforming and MIMO(MIMO may or maynot be needed) and WMM. Under Advanced Tab/Advanced Settings/Wireless Settings

    Try disabling the following and see:
    Armor, Circle, Daisy Chain, Fast Roaming, IPv6 and Set 20/40Mhz Coexistence to 40Mhz only. Set Short preamble instead of Long preamble modes. Save settings and reboot the router and satellite(s).

     

    Above suggestions working:
    https://community.netgear.com/t5/Orbi/Throttling-Devices-RBK53/m-p/1858561/highlight/true#M81925

     

    Has a factory reset and setup from scratch been performed since last FW update? 


    danfCO wrote:

    I have one RBR50 and two RBS50 satellites all running V2.5.1.8. Internet has been very stable. Each night over the last 5 nights, My devices are not able to reach the internet. When I log into my orbi system, it says the internet connection is good. I can't seem it isolate the issue. I reboot the system in the morning and it then works fine for the day unitl I wake up and find the same issue. 


     

    • Retired_Member's avatar
      Retired_Member

      :smileysad:

       

      no copy paste will fix bad FW