NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
RBR/RBS 50 firmware 2.7.3.22
New firmware is incoming this week I have been told. No release notes details yet but may fix either device list issues or link rate issue. Keep an eye on https://www.netgear.com/support/product/RBK50...
scubabuddy wrote:RBR50 + 2 x RBS 50 firmware just upgraded from 2.7.2.104 to 2.7.3.22
* no "enable telnet" option, so no way to properly diagnose or fix
Hi there,
Facing the same issue, I could restore telnet access using the updated version of telnet-enable2.py, enabling back Telnet using V2.7.3.22: https://github.com/bkerler/netgear_telnet
I could push all my existing custom configuration (upnpc, automation, etc.) from here.
Hope this will help you as well...
mmz06 wrote:
scubabuddy wrote:RBR50 + 2 x RBS 50 firmware just upgraded from 2.7.2.104 to 2.7.3.22
* no "enable telnet" option, so no way to properly diagnose or fix
Hi there,
Facing the same issue, I could restore telnet access using the updated version of telnet-enable2.py, enabling back Telnet using V2.7.3.22: https://github.com/bkerler/netgear_telnet
I could push all my existing custom configuration (upnpc, automation, etc.) from here.
Hope this will help you as well...
Hi,
The tool sounds promising. However I wonder if you can clarify
- How do you find the MAC address of br0 interface?
- It says the tool is for Netgear Orbi LBR20. Are you using LBR20? If not, did you need to make any changes to get it working with your Orbi router?
Thank you very much .
Joseph
I use the Python script to enable telnet on RBR50 and RBS50.
I loaded Python 3 on Windows 10. Learning enough about Python to get a script to run was a struggle for "the old guy".
Every time my Orbi router or satellite reboot, I run the Python script to enable telnet and then use telnet to do a couple of things.
The MAC address of the router shows up in the Attached Devices web page.
