NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
RBS40 not syncing on ethernet backhaul
Hello all, I am running 1 x RBR40 w/ 2 x RBS40 in AP mode. Both satelites connected using ethernet backhaul. One of the satelites works fine everytime and gets the blue ring on top. However, ...
Yeah hello all again.
Seems like it's gone and broken itself again.
Now, it's starting to affect the whole network as well. I'm getting random connection drops for all devices across the network and the previous un-cooperative satelite now shows as doing backhaul on 5G even though it is way too far away to do that.
I've tried the above suggestions but they don't seem to be helping.
Any more ideas? Thanks anyways
Factory reset the RBR and RBSs and setup from scratch.
Disable Daisy Chain on the RBR.
I would set up each RBS near the RBR while in the same room first. Wirelessly first then once they are confirmed wirelessly connect at the RBR, connect 1 RBS directly to the RBR with a LAN cable. Don't use any switches. Give it a few minutes. The top ring LED should turn BLUE the go OFF. Do this for the 2nd RBS as well. Once you get them ethernet connected. Turn them OFF and place back in there remote locations.
Be sure to rebooted or power cycle any and all networking devices. After you setup the RBR. Helps clear out any IP conflicts that maybe causing problems.
Is there a ethernet switch being used or are the RBS directly connected to the RBR? If so, what is the Mfr and model#?
snoopy1212 wrote:Yeah hello all again.
Seems like it's gone and broken itself again.
Now, it's starting to affect the whole network as well. I'm getting random connection drops for all devices across the network and the previous un-cooperative satelite now shows as doing backhaul on 5G even though it is way too far away to do that.
I've tried the above suggestions but they don't seem to be helping.
Any more ideas? Thanks anyways