NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Firmware 2.2.1.210 released as of 10/3/18
New firmware is available via the GUI ....
Let's hope for success.
Possile this may have been intended as a more simple way to show connected devices on the router. Maybe NG support can provide some behavior information.
deesto wrote:
jblack68 wrote:
I have factory reset everything and started again, the Router GUI is completly wrong, showing devices connected to Router instead of Satellite, 2.4ghz instead of 5ghz. it's a mess.
I also have some devices plugged in via ethernet showing up as hooked to the router on its GUI, instead of correctly being reported as wired onto the satellite.
Another bug:
It’s enabled the guest network without my knowledge while the GUI says it’s off. Had to enable it and disable it to make sure it’s off.
Very buggy firmware.
It’s enabled the guest network without my knowledge while the GUI says it’s off. Had to enable it and disable it to make sure it’s off.
Very buggy firmware.
Thank for letting us know. Did you just update FW and continue or factory reset the router and set up from scratch?
What browser are you using?
jblack68 wrote:
Another bug:
It’s enabled the guest network without my knowledge while the GUI says it’s off. Had to enable it and disable it to make sure it’s off.
Very buggy firmware.- Updated and factory reset it. Used safari and chrome. Another bug is that if you set devices names like Adam’s iPad. The ‘ gets glitched on the Orbi iOS app. Adam#39,s iPad. This did not happen on previous firmware.