NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Satellites won't display device name after update to FW 2.5.1.8.
Had a power outage which required me to reset all my IOT devices, etc. Decided it would be good time to update FW to 2.5.18 from 2.3.5.30. Went smoothly without factory reset. Good speeds and connect...
Did the upgrade three days ago. I've learned over the years I've used the ORBI to allow significant "settling time" before rushing to change anything.
As I said it isn't big deal but I may resort to factory reset. If I only did satellites would that cause more issues?
A factory reset on satellite only is about the least disruptive thing you can do. Nothing changes on the router, so there is no reconfiguration to do.
I may do a satellite factory reset when I have some time to turn off the 20+ devices attached to the satellites. Bit of a PITA, but I do it every time I upgrade firmware. Seems to keep the system stable and devices pretty much stay attached to the "correct" satellite.
Thanks for your help!
tucsontico wrote:I may do a satellite factory reset when I have some time to turn off the 20+ devices attached to the satellites. Bit of a PITA, but I do it every time I upgrade firmware.
I would be tempted to do the reset and see which devices "connect incorrectly" rather than power all of them off.
I'll attempt that today. Seems logical to try a satellite factory reset without power cycling my devices to see if they'll conncet correctly to the physically nearest satellite. If they do not, I can power cycle the devices to get correct connections. Thanks!