NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
sonicspriter202
Jul 03, 2021Aspirant
Severe Packet Loss on Orbi RBR50
To whom this may concern, I have purchased my Orbi RBR50 last year at a local BestBuy, since I needed a stable Wi-Fi extension that can extend my connection due to my router being at the opposite...
- Jul 06, 2021
What Firmware version is currently loaded?
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?What are you testing with to check packet loss?
I'd turn OFF all RBS and all wired and wireless devices and test with just one wired PC connected at the ISP modem and check packet loss here first using pingplotter.com. Then test with the RBR in the middle.
FURRYe38
Jul 06, 2021Guru - Experienced User
What Firmware version is currently loaded?
What is the Mfr and model# of the Internet Service Providers modem/ONT the NG router is connected too?
What are you testing with to check packet loss?
I'd turn OFF all RBS and all wired and wireless devices and test with just one wired PC connected at the ISP modem and check packet loss here first using pingplotter.com. Then test with the RBR in the middle.
- sonicspriter202Jul 06, 2021AspirantI tried turning off the satellites and disconnecting each device individually until I found one that was causing packet loss.
After that process, I found out that it was my PS4 that was using up majority of the Wi-Fi bandwidth.
The games I used to benchmark the packet loss issues were Brawlhalla and Fortnite.
I will keep you guys updated if the packet loss issues occur again. Thanks for the help!- FURRYe38Jul 06, 2021Guru - Experienced User
Please mark your thread as solved so others will know.
Enjoy.
- RookAAug 06, 2021Aspirant
FW - V2.7.3.22 for both Router and Satellite.
Modem - Arris BGW210-700
I have been using pingplotter to check packet loss once I noticed it occuring.
I tested with my pc wired to just the modem and no other devices on the network for about an hour and ping stayed under 30ms with <1% PL. I then connected the RBR to the modem and hardwired the pc to the RBR and again experienced no higher than 30ms ping with <1% PL.
Then I added the satellite back into the mix. It is 1 floor directly above my modem and router and gave a blue ring following syncing. (It still shows a "config sync" status in orbilogin.net). However, I disabled my WLAN card in my pc and hardwired to the satellite to ensure no interference. I saw roughly 5-7 ping spikes a minute at hop 1 carried through to the destination up to ~2900ms. PL% was around 28% for the duration.
- FURRYe38Aug 06, 2021Guru - Experienced User
Your ISP Modem already has a built in router and wifi. This would be a double NAT (two router) condition which isn't recommended. https://kb.netgear.com/30186/What-is-Double-NAT
https://kb.netgear.com/30187/How-to-fix-issues-with-Double-NAT
Couple of options,
1. Configure the modem for transparent bridge or modem only mode. Then use the Orbi router in router mode. You'll need to contact the ISP for help and information in regards to the modem being bridged correctly.
2. If you can't bridge the modem, disable ALL wifi radios on the modem, configure the modems DMZ/ExposedHost or IP Pass-Through for the IP address the Orbi router gets from the modem. Then you can use the Orbi router in Router mode.
3. Or disable all wifi radios on the modem and connect the Orbi router to the modem, configure AP mode on the Orbi router. https://kb.netgear.com/31218/How-do-I-configure-my-Orbi-router-to-act-as-an-access-point and https://www.youtube.com/watch?v=H7LOcJ8GdDo&app=desktopIf your not seeing a GOOD status and only Config Sync, then the RBS is not fully syncing correctly. You'll need to remove the prior RBS connection from the RBR, apply the setting there. Factory reset the RBS and then attempt to re-sync it. IF this fails, you'll need to factory reset the RBR and RBS and setup from scratch.
RookA wrote:
FW - V2.7.3.22 for both Router and Satellite.
Modem - Arris BGW210-700
I have been using pingplotter to check packet loss once I noticed it occuring.
I tested with my pc wired to just the modem and no other devices on the network for about an hour and ping stayed under 30ms with <1% PL. I then connected the RBR to the modem and hardwired the pc to the RBR and again experienced no higher than 30ms ping with <1% PL.
Then I added the satellite back into the mix. It is 1 floor directly above my modem and router and gave a blue ring following syncing. (It still shows a "config sync" status in orbilogin.net). However, I disabled my WLAN card in my pc and hardwired to the satellite to ensure no interference. I saw roughly 5-7 ping spikes a minute at hop 1 carried through to the destination up to ~2900ms. PL% was around 28% for the duration.