SONOS One can't works in RBR20 with Wireless (only one RBR20,No satellite)

What Firmware is currently loaded?
What is the Mfr and model# of the ISP modem the NG router is connected too?

What is the size of your home? Sq Ft?
What is the distance between the router and satellite(s)? 30 feet is recommended in between them to begin with depending upon building materials when wirelessly connected.

What channels are you using? Auto? Try setting manual channel 1, 6 or 11 on 2.4Ghz and any unused channel on 5Ghz.
Any Wifi Neighbors near by? If so, how many?

Try enabling Beamforming and MIMO(MIMO may or maynot be needed) and WMM. Under Advanced Tab/Advanced Settings/Wireless Settings

Try disabling the following and see:
Daisy Chain, Fast Roaming, IPv6 and Set 20/40Mhz Coexistence to 40Mhz only. Save settings and reboot the router and satellite(s).

Try this, just temporarily disable the 5Ghz SSID broadcast while you set up SONOs on 2.4Ghz. Under Advanced Tab/Advanced Settings/Wireless Settings. Once setup, re-enable the 5Ghz SSID broadcast. 

---

JohnZxm wrote:

I have two sonos one device, It works connect to R6200 with wireless in before. As R6200 using so long time, So I buy new one ORBI RBR20 router replace r6200. After that time, My sonos can't work properly. The speed often just have 1M or 2M. and often lost connect , I need to rebuild the wifi connect then can found it. SONOS support engineer no ideal. Try so long time, They can't solved this problems.They reply me t is ORBI wireless network issue.

I using cable direct connect no problems.  Did anyone have the same problems?  Netgear support ,could you tell me how to solved this issue.

I also try seperate the 2.4G and 5G SSID, But not success.

 

 

 

 

 

---