Forum Discussion

Aspirant

Apr 19, 2019

Solved

Unable to Map drives after setting up Orbi RBR50 mesh network

I have updated my Netgear router to the Orbi RBR50 Mesh network. Since then I have not been able to map drives to computers around the house. Windows says that it is able to connect but the device is...

FURRYe38
May 02, 2019
Glad you found the problem and fixed it.

Please mark your thread as solved so others will know for future referece.

Enjoy. :smileywink:

finny23j

Aspirant

Apr 22, 2019

Firmware: V2.3.1.44

Cisco Type: XB3, Model : DPC39541T

Cleared my mapped drive on the device I setup the share on.

Recreated the share on the device.

Tried to map drive to //IPAddressOfDevice\DataVolume

Verified that firewalls are disabled the windows 10 device

It still failed to map a drive.

FURRYe38

Guru - Experienced User

Apr 23, 2019

Is this your ISP modem?

https://www.cnet.com/products/cisco-model-dpc3941t-docsis-3-0-24x4-wireless-residential-voice-gateway-wireless-router-cable-mdm-802-11b-g-n-ac-desktop/

If so then this already has a built in router and wifi. This would be a double NAT condition which isn't recommended. Couple of options,
1. Configure the modem for transparent bridge mode. Then use the Orbi router in router mode. You'll need to contact the ISP for help and information in regards to the modem being bridged correctly.
2. If you can't bridge the modem, disable ALL wifi radios on the modem, configure the modems DMZ or IP Pass-Through for the IP address the Orbi router gets from the modem. Then you can use the Orbi router in Router mode.
3. Or disable all wifi radios on the modem and connect the Orbi router to the modem, configure AP mode on the Orbi router. https://kb.netgear.com/31218/How-do-I-configure-my-Orbi-router-to-act-as-an-access-point and https://www.youtube.com/watch?v=H7LOcJ8GdDo&app=desktop

finny23j
Aspirant
Apr 23, 2019
I would do one of the options you have suggested, but all my devices are connecting to the orbi network and not at all to the Cable modem network. Are these options still needed?

Thanks,
- FURRYe38
  Guru - Experienced User
  Apr 23, 2019
  Would be something to try.
  
  Seems odd that you can't map drive for some reason...even with all connected to the Orbi. Ensure all devices are using the same workgroup name as well.
  
  Try this, connect 1 PC and 1 remote share device to the ISP modem. Map drive there work?
  - finny23j
    Aspirant
    May 01, 2019
    Hey Furry,
    
    Some more investigation with the device I am trying to map to, I found that I had updated the anti-virus to Norton and it automatically blocked filesharing. Once I added the devices as "Trusted Devices" I was able to map drives to them.
    
    Thanks again for your suggestions. It was very helpful.