NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Netgear M5 EU - user experiences
Hi, I have been fieldtesting this device for few days now. Does anyone else have user experiences of this device by now?
Here pictures from yesterday, I was fieldtesting M5 EU at Oulu, Northern Finland. DNA 5G basestation(Huawei RAN).
5G ENDC combo: B28@10MHz+B3@20MHz+B7@20MHz+B1@20MHz+n78@100MHz.
Do you have a technical datasheet where it says about the bands it can aggregate.?? I am not talking about the default datasheet
Well, some CA combo support lists do exist, but these are not public data. Do you have some specific CA combo support question in mind? Generally speaking M5 EU CA combo support is still evolving and level of CA combo support is wide. I have been using device with 5CC LTE+NR and latest firmware 12.03.09.00 PRI 03.03 Firmware build date: 2021/04/09 supports 6CC LTE+NR.
- Thanks, looking for the below combos
40A+40A,
40c
3A+40A
3A+40A+40A
1A+3A+40A+40A
N3+3 , N40+40, n3+40, N40+3 40A+40A, :YES
40c :YES
3A+40A :YES
3A+40A+40A :YES
1A+3A+40A+40A: NO
N3+3 :NO
N40+40 :NO
n3+40 :NO
N40+3 :NOThis is my opinion to asked CA combo support question. Please keep in mind this may not fully represent what the latest firmware could have. RAN side must be properly configured too. Always a good method to capture UE Capability message's from specified network and decode these to see what's happening between network and terminal.
- Ok Thanks!!
Does Netgear M5 supports Dynamic Spectrum Sharing DSS?? It is a x55 modem , I believe it should.. buy need your opinion.
What application are you using to decode the band transmission information between RAN and UE ?? I think DSS was enabled in 10.29.11.00 PRI 02.17 version Build date 2020/11/26.. QCAT tools for example can be used for log analysis,
- Thanks for you reply.
In at command of MR5200 it shows the mmWave bands are all 00000000000000. Does MR5200 supports mmWave and is disabled now , which can be enabled by Netgear later by firmware updates?? MR5200-100EUS, what is called as EU-model does not have Qualcomm mmWave-antenna module inside. Actually at this moment EU area commercial terminal support for mmWave is extremely rare.
- There is one from Poland Play telecom. ZTE MC7010. Supports n257 and n258 of mmWave in Europe
Actually I have done some experiments with ZTE MC7010 (Poland model)in Finland and it did not work well. Bad problems with n78 downlink with all Finnish operators..
- Oh ok. Thanks for your reply. I sent you private message