New Firmware -- Overtemp warning

 

Does the MR1100 Nighthawk log errors that record that it has overheated at some time?  

---

JSchnee21 wrote:

Saw a new message and icon on my mr1100 since updating to the most recent AT&T firmware a week or so ago.

While it's good that the mr1100 now tells you why it is not charging -- due to battery/device over temp.  Both in words and with a spiffy new icon (see attached).

 

But, it doesn't change the fact that the unit is way too temperature sensitive.  The otherday I went to charge my device after only an hour or so normal usage.  The mr1100 was slighlty warm in my hand from usage on a mild summers day (in the shade).  And it refused to charge.

 

I had to turn the unit off, remove the back cover, and let it sit open for 30min or so to get it to accept a charge.  Of course then, when I plugged in the power to charge the unit annoyingly turns on.  So then I had to wait for it to boot, then shut it down, all because the safety temp thresholds are way to low (or sensors are not properly calibrated).

 

 

---