Forum Discussion

Guide

Feb 03, 2021

red light

Hi All Help needed my Mr2100, as a red flashing light showing no wifi signal so can't connect. Sid is ticked but not broadcasting the wifi, works via ethernet, light flashes blue but when unplug...

stopper9327

Guide

Feb 06, 2021

Hi Blanca

Thanks for replying, I can confirmed that the wifi stanby is set to disabled, mt sku is : SKU:MR2100-1EEEUS, I have a EE data sim

for the device which was working perfectly until now. The firmware is NTGX24_10.13.09.00 do you think my firmware could be corrupted?

regards

stopper9327

Blanca_O

NETGEAR Employee Retired

Feb 08, 2021

Hi stopper9327

Were you able to check if there is a new firmware update available?

Kindly do a factory reset using the Reset button. Press and hold the Reset button for five seconds. The mobile router returns to factory settings.

Regards,
Blanca
Community Team

stopper9327
Guide
Feb 08, 2021
Hi Blanca

I can confirm that I have checked for a firmware update, and I have tried some of the forums solutions i.e data offloading trick with no success. Also done factory reset a few times and still the same results red X near wifi, not correcting it.
regards
stopper9327
- Blanca_O
  NETGEAR Employee Retired
  Feb 08, 2021
  Hi stopper9327
  
  I have sent you a message. Please check your inbox.
  
  Regards,
  Blanca
  Community Team
  - Matty_K85
    Tutor
    Feb 09, 2021
    Hi guys,
    
    Mine is doing exactly the same, was working fine until I did a firmware update and now no wifi and red flashing power button. Can also connect via USB.
    
    Any updates? Is there a resolution or is this a hardware issue?
    
    Cheers,
    
    Matt