NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
GS752TPV2 Web UI login only works after power cycle
Hi All, Our company has about 10 of the Netgear GS752TPv2 switches that are being used as access switches. I recently updated the firmware to version 6.0.8.2 and everything was working good for ...
I just tried logging into several of the switches this morning through the web UI and the same issue is happening. I enter the password, click "GO" and nothing happens. Completely cleared all browser cache and even reset the browser to default but getting the same problem. All the switches are switching normally but no management access!
We need a solution for this or we will be going to Cisco switches asap.
Here are my suggestions:
1. Perform a factory reset then reconfigure the settings from scratch and check if the same problem will occur.
2. NETGEAR has recently released a new GS752TPv2 firmware which is v6.0.10.10. I suggest you to update again the firmware of your Gs752TPv2 then perform a factory reset and reconfigure the settings from scratch. Observe if the same problem will occur.
You can download GS752TPv2 firmware v6.0.10.10 here.
3. If #1 and #2 did not help, it would be best to open a support ticket with NETGEAR Support here at anytime for a hardware check.
Regards,
DaneA
NETGEAR Community Team
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
