NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
WAN Port
Hello Excuse the noob question. We had a small 4 port router that plugged into the switch and provided internet access. It was setup using dhcp for internal ip addresses. We've upgraded to a d...
You need to add some NAT router...there is no such NAT and PAT support on any Netgear switch.
- Ok can you recommend a device that would make this work? If I understand you then this device would plug in between my netgear switch and the cisco router supplying the internet connection?
This reads like your ISP has configured an interface on this router providing a complete IPv4 subnet.
Do you have management control over this Cisco router? There might be a way to add some NAT routing and configure a DHCP server for a new LAN subnet.
As you have obviously no need for a complete network block, you should return this as public IPv4 addresses are a rare good. this might lower the monthly costs, too.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
