NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
FVS-318N; FVS-318Gv2 and Arris
- I am trying to configure IPSec VPN tunnel with GPRS Modem (Make: Maestro,
Model E225 Lite)
- while configurating VPN Wizard its asking for following:
| What is the Remote WAN's IP Address or Internet Name? | ???? |
- But at remote end there is GPRS modem with local SIM card (No static IP)
- Same time in IKE Policy remote END parameter what should be the identifier and identifier Type.
- requesting you to help me to resolve this issue..
Thanks in advance..
3 Replies
Hi nmwakde,
The Remote WAN IP Address is the Public WAN IP Address that is registered on the GPRS Modem. You may want to check the user manual of your GPRS modem to know where you can get the information about its WAN IP Address as well as the IKE Policy remote END parameter identifier and identifier type.
Just to verify, are you setting up a Box-to-Box IPSec VPN Tunnel or Client-to-Box IPSec VPN Tunnel? Either way, kindly access the articles below and use it as your guide:
Configuring a Box to Box VPN on ProSAFE/ProSECURE routers using the VPN Wizard
ProSAFE VPN Client: Client to Box Configuration
Regards,
DaneA
NETGEAR Community Team
forget to mention below in previous mail:
-communicate type is gateway to gateway ..
I just want to follow-up on this. Were you able to get the WAN IP Address as well as the IKE Policy remote END parameter identifier and identifier type of your GPRS modem? Hope this user manual I found online would help.
Regards,
DaneA
NETGEAR Community Team
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
