NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
Routing on FVS336GV2 two subnets one to each wan port
I have a FVS336GV2. On our network I have two subnets 192.168.2.x, plugged into the LAN port. 192.168.1.x plugged into the DMZ port. How do I route all LAN traffic to WAN1 and all DMZ traffic to WAN2...
Hi MZabel67,
Welcome to the community! :smileyhappy:
Here below are the steps of what I think might help:
a. Select Load Balancing on WAN Mode.
b. Configure Protocol Binding to allow any service on the 192.168.2.x network on WAN1 port.
c. Configure DMZ WAN Rules and select WAN2 port for the 192.168.1.x DMZ network.
Kindly check these articles below as reference guides:
http://documentation.netgear.com/fvs336g/enu/202-10257-01/FVS336G_RM-04-12.html
http://kb.netgear.com/app/answers/detail/a_id/24326
Let me know if it works.
Regards,
DaneA
NETGEAR Community Team
Hi Mzabel67,
On the web-GUI of the FVS336Gv2, click Monitoring then click Router Status. In the WAN Information section, is the WAN IP Address registered on both WAN 1 and WAN 2, are they both Public IP Addresses?
I think you may upgrade the firmware to the latest firmware version which is v4.3.3-6. Be reminded to perform a factory reset after successfully upgrading the firmware then reconfigure the device from scratch.
Regards,
DaneA
NETGEAR Community Team
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
