NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
re-discover managed access point
Good afternoon, controller: 7600 access point: WAC720 Access point was no longer used, disconnected from network, and removed from managed access points list. Now I need it back to work with t...
If it is the same wireless controller, you don't need to re-install the standalone firmware but it will depend if the AP is running on the same firmware as the controller. if you are not sure about the installed firmware then It would be best to install a standalone firmware and discover it using the controller.
Regards,
John
NETGEAR Community Team
thank You for Your reply.
So, assuming it is same firmware:
When I remove (configured and working) access point from 'managed AP list' then I should be able to re-discover this AP again if I use Discovery wizard?
regards
That is correct. Just use the discovery wizard from your controller and you may be able to detect the access point. Just let me know if that will not work.
Regards,
John
NETGEAR Community Team
hi, thank You for Your reply,
unfortunatelly this did not work.
I tried auto discovery and picked subnet as well
regards
Please open a ticket on NETGEAR support and please let them know the status of your access point. You may also include this thread.
Regards,
John
NETGEAR Community Team
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
