NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Other devices don't show up on the Netgear Genie "Client" App .
I have 4 Wireless IP Cameras (3 X Foscam, 1 Dlink) + several computers, NAS, printer, etc..
For some reason, 2 of the 4 ipcameras dont show up on the Attached Devices Pane nor the printer.
BUT: a...
All my devices uses DHCHP. I did however set use the Address Reseravation menu to prevent them to switch IP under;
Advanced --> Setup --> Lan Setup -- Use Router as DHCP Server --> Address Reservation
Then again, All my devices are setunder Address Reservation and only the printer and 2 IP Cameras are missing.
All 4 IP cameras are setup the same way.
Can you check the logs on the router and confirm that the 2 IP Cameras and printer are being assigned IP addresses by the router?
Does the problem persist across a reboot of the router?
All 4 IP cameras incl. the 2 missing and the printer are listed in the log ...[DHCP IP: (192.168.1.8)] to MAC address...
And yes, the problem still persists after router was rebooted (Firmware 1.0.2.44).
In addition, support made me upgrade the Firmware to the latest release (1.0.2.46), therefore it was rebooted again... the problem was not resolved.
Strange. Well, I only have a couple more ideas left.
- Do you have Access Control enabled? If so, make sure that the missing devices are not blocked. Better yet, disable Access Control altogether.
- Try removing the Address Reservations, temporarily, for the missing devices. Restart the devices.
I disabled Access Control, removed the Printer IP from the Address Reservations, shutdown and restarted the printer... no change, its still missing from "Attached Devices".