Blinking white light for MS60

Any progress on this? 

---

Ian57 wrote:

Had 2 full M60 systems. Both routers setup, 1 as an AP. 3 of the 4 sats setup around the house. Yesterday I had to reboot main router and even factory rest it. Today it all crashed, nothing worked. I ended up doing a full reset and setup of the main router. Some of the sats will connect but the AP router just blinks white. 

1. Rebooted at least 10 times
2. Sync'd
3. Factory reset button

Nothing will get it off that blinking white light. I believe trying to resolve the issues yesterday I got it out of AP mode and into bridge mode or it simply is just stuck as AP mode but with a conflicting IP.

 

Note: my phone shows a NETGEAR_SETUP as an open network. This was not there 2 days ago. I assumed I needed to connect to that so I could then edit the IP and/or settings for the AP router. It never connects, spins and finally says...IP address Failure. Again leads me to believe it has conflicting IP with the main router.

 

I need to find out how to fully factory reset this thing, then I should be able to hook it up, login, and make the changes i need to put it back as AP router. If I can't am I just stuck with a dead weight?

 

Any suggestions greatly appreciated.

---