NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
Netgear Nighthawk Mesh - 1 satellite always goes down
One of the satillites gets disconnected and takes even couple of days to reconnect. Support team asked me to return and get a new one. I have done that twice and I still face the same issue. Ret...
when you swap the c6900 to modem only, make sure to reboot the c6900 and the mk system. Also make sure only the mk router is connected to the c6900.
Putting the MK system into access point mode is pretty simple. Page 67 of the manual goes over that. Find the manual here:
What mesh system do you have?
you're also using the c6900?
Has the router portion of the c6900 been disabled?
or the mesh system in access point mode?
How far from the main router is the satellite?
what are your interior walls made of?
What mesh system do you have?
Nighthawk mesh wifi 6 system (AX1800 - MK63 / MK60 satillite)
you're also using the c6900?
Yes. C6900 is Modem router connected from ISP and MK63 is connected to C6900
Has the router portion of the c6900 been disabled?
No.
or the mesh system in access point mode?
No
How far from the main router is the satellite?
around 60-70 feet. Router is on 2nd floor and satellites are in 1st floor
what are your interior walls made of?
Drywall
cascading routers is a recipe for network issues. its called double nat.
What is Double NAT? | Answer | NETGEAR Support
You can try the C6900 in modem only mode or put the MK router in access point mode.
I tried making the c6900 as modem only then, Nighthawk mesh MK63 was not recognized.
The connectivity is ISP connecting to C6900 (modem **bleep** router) and am connecting to MK63.
Advice me on how to setup MK63 as access point.
Thanks,
Vasudevan